Quality

Inspecting LED strip lights from China before they ship

Voltage drop, colour temperature, CRI, IP rating, solder joints and the adhesive tape. What to check on LED strips at the factory and what needs a lab.

By Packsel Consulting, Purchasing insights
Article date: · 3 min read
Updated:

LED strips with similar photographs and advertised specifications can perform differently in use. Brightness along the reel, color consistency and adhesive performance are among the characteristics to assess. Defining inspection and test requirements gives buyers a clearer basis for accepting the order.

Most of these differences can be checked before the goods leave the factory.

Things an inspector can check on site

Dimensions and construction. Measure the strip width, the cut-point spacing and the LED count per metre against the spec. Look at the flexible circuit board: a thicker copper layer (often specified as 2 oz rather than 1 oz) carries current better and reduces voltage drop. The factory should be able to show you the board spec.

Solder joints. Check the joints at the LEDs, resistors and the connector or lead wire. Cold or incomplete joints show up as dull, grainy solder and are a common source of dead sections later.

Voltage drop over a full reel. Power a full 5 m reel from one end at the rated voltage and compare brightness at the start and end. A light meter makes this objective. Agree beforehand how much difference you’ll accept.

Colour consistency. Lay several reels side by side, lit, and look for visible differences in white tone. LEDs are sorted into “bins” by colour; mixing bins within an order shows up immediately in a long run.

Adhesive tape. Check the brand and type of tape against the spec. Stick a sample to the surface type your customers use, leave it, and test the peel.

IP rating construction. For a silicone-coated (often marketed as IP65) or encapsulated (IP67 or IP68) strip, check the coating is even and fully covers the board, with no bubbles at the cut points or end caps.

Packaging and labels. Reel labelling, voltage and wattage markings, and the power supply in the box if included.

Things that need a lab or proper instruments

Colour temperature (CCT), colour rendering (CRI) and total light output are measured with a spectrometer or an integrating sphere. A factory may have one; you can ask for readings on a sample from your batch and watch the test. For a claim on the packaging, an independent lab report is stronger.

Electrical safety certification is a separate matter. Products sold through many U.S. retailers are expected to carry a listing from a recognised testing laboratory such as UL or ETL. An inspection doesn’t replace that, and the certification should be for the product you are actually buying, not a similar one.

Write the acceptance criteria first

Before the inspection, agree in writing:

  • LED type and count per metre, board width and copper weight
  • voltage, wattage per metre, and allowable brightness drop over a reel
  • CCT and CRI targets, and how they will be measured
  • tape type
  • coating type and IP claim

How we inspect LED strips

On an LED strip inspection, we power a full reel from one end and photograph the first and last LEDs at the same settings. We check solder joints with a magnifier, lay several reels side by side to compare colour, and check the tape and coating. Where the client needs measured colour data, we arrange a lab test.

Packsel Consulting carries out pre-shipment inspections on lighting products and will tell you up front which checks we perform and which need a lab.

About these articles

Packsel Consulting

Purchasing insights · U.S. and Hong Kong

Practical guidance for U.S. businesses buying from Asia.

How we work
More insights

Get in touch

Tell us what you’re buying.

Send us the product, the supplier if you have one, and your dates. We’ll suggest a scope for one stage or the whole order.